Operation Instruction of Tapping Machine
- 1.First of all, check if the machine is damaged or the base is steady or not.
- 2.Make sure if it is single phase or three phase or 220V or 380V power before plugging into the power.
- 3.Make sure if the pulley is smooth before turning on the machine. Apply grease oil before operation as figure C. Make sure to clean up the oil of spindle before installing the chuck and then knocked by plastic hammer for six times, from down to top.
- 4.Make sure the spindle turning direction is correct after turning off the machine. For right tapping, the spindle is counterclockwise, but for left tapping, the spindle is clockwise.
- 5.Lock tightly the screw by using chuck wrench before tapping. Install the long wrench on the hole base of right linkage bar to lock the nut.
- 6.Make sure to be aimed at the screw hole before tapping and then press the long wrench for tapping. After tapping to the screw size, release the hand and the spring will return back to the position before tapping.
- 7.Adjust the tapping depth, C2 is to adjust the speed of pulling force and C3 is to adjust the tapping depth.
- 8.Figure B is to adjust the tightness of clutch and the belt can not be too tightened.
★Patent No. 26280★
A.For right tapping, turn left, but for left tapping, turn right. To adjust the direction is to convert the two motor lines, 5 and 6.
- B.The tightness of clutch’s belt can not be too tightened, take Figure D as the adjustment standard of belt tightness.
- C.
- 1. Apply grease oil before working.
2. Adjust upward or downward can affect the speed of pulling force.
3. Adjust the depth of tapping.
